Synonymer & Information om | Engelska ordet MAINSAIL


MAINSAIL

1

Antal bokstäver

8

Är palindrom

Nej

16
AI
AIL
AIN
IL
IN
INS

1

1

529
AA
AAI
AAL
AAM


Sök efter MAINSAIL på:



Exempel på hur man kan använda MAINSAIL i en mening

  • A sloop is a sailboat with a single mast typically having only one headsail in front of the mast and one mainsail aft of (behind) the mast.
  • Most modern designs have only one sail, the mainsail; however, the traditional catboat could carry multiple sails from the gaff rig.
  • A brigantine is a two-masted sailing vessel with a fully square-rigged foremast and at least two sails on the main mast: a square topsail and a gaff sail mainsail (behind the mast).
  • The bilander, also spelled billander or bélandre is a two-masted vessel, the foremast carrying square rigs on all of its yards and its taller mainmast having a long lateen mainsail yard with corresponding trapezoidal sail and rig inclined at about 45° with square rigs on the yards above that, the lowermost secured at the corners by a crossjack.
  • The tack is the corner on a fore-and-aft sail where the luff (the forward edge) and foot (the bottom edge) connect and, on a mainsail, is located near where the boom and mast connect.
  • The usual sailing rig was single masted, with a gaff mainsail and two headsails - the jib was set on a bowsprit and the staysail to the stemhead.
  • Historical fore-and-aft rigs used a four-sided gaff rigged mainsail, sometimes setting a gaff topsail above it.
  • The Star was originally rigged with a large, low-aspect-ratio gunter mainsail and jib, which was replaced by a short bermuda rig gradually during the early 1920s, before the current tall bermuda sail plan was adopted in 1930.
  • Small sailboats also called dinghies are commonly made from fiberglass, and will have wood, aluminum, or carbon-fiber spars, and generally a sloop rig (two sails: a mainsail and a jib, commonly include 3rd sail the spinnaker for going downwind).
  • The rigs of pinnaces included the single-masted fore-and-aft rig with staysail and sprit mainsail to the mizzenmast, and a square sprit-sail under the bowsprit.
  • Another form of preventer is the boom brake, which, when sailing downwind, can also be used to jibe the mainsail in a slow, measured action.
  • The rig consists of a triangular sail set aft of the mast with its mainsail raised to the top of the mast; its luff runs down the mast and is normally attached to it for its entire length; its tack is attached at the base of the mast; its foot (in modern versions of the rig) controlled by a boom; and its clew attached to the aft end of the boom, which is controlled by its sheet.
  • The courses are given a name derived from the mast on which they are set, so the course on the foremast may be called the fore-course or the foresail; similarly main-course or mainsail for that carried on the mainmast.
  • The lowest and normally largest sail on a mast is the course sail of that mast, and is referred to simply by the mast name: Foresail, mainsail, mizzen sail, jigger sail or more commonly forecourse etc.
  • The typical couta boat carried a gaff sail and jib, set out on a long bowsprit, although the mainsail developed into more of a gunter sail, because it had a very high-peaked gaff or yard.
  • The mainsail had to be smaller to clear this stack (this could be achieved by reefing), and the foresail would be sheeted to a temporary wire horse.
  • A jackline is also a rope installed in the luff of a mainsail to allow the luff slides to migrate horizontally away from the mast when the sail is reefed.
  • The boat has a 3:1 purchase downhaul (upgradable to 6:1) to tension the mainsail and an outhaul (standard 1:1, upgradable to 2:1) to flatten the mainsail along the boom.


Förberedelsen av sidan tog: 340,06 ms.