Anagram & Information om | Engelska ordet RESISTOR

Exempel på hur man kan använda RESISTOR i en mening

• A resistor is a passive two-terminal electrical component that implements electrical resistance as a circuit element.
• A thermistor is a semiconductor type of resistor whose resistance is strongly dependent on temperature, more so than in standard resistors.
• Analog voltmeters move a pointer across a scale in proportion to the voltage measured and can be built from a galvanometer and series resistor.
• Heating is usually achieved by sending electricity through a resistor consisting of a hot incandescent filament, with the expanded gas expelled through a conventional nozzle.
• It is defined as "the temperature of a resistor having an available thermal noise power per unit bandwidth equal to that at the antenna's output at a specified frequency".
• It is also more accessible than speaking of the noise's power spectral density (in watts per hertz) since it is expressed as an ordinary temperature which can be compared to the noise level of an ideal resistor at room temperature (290 K).
• Center tap, a wire that is connected halfway along one of the windings of a transformer, inductor or a resistor.
• In the hydraulic analogy, current flowing through a wire (or resistor) is like water flowing through a pipe, and the voltage drop across the wire is like the pressure drop that pushes water through the pipe.
• In the 1920s, the RMA resistor color code was developed by the Radio Manufacturers Association (RMA) as a fixed resistor coloring code marking.
• A potentiometer is a three-terminal resistor with a sliding or rotating contact that forms an adjustable voltage divider.
• Joule also made observations of magnetostriction, and he found the relationship between the current through a resistor and the heat dissipated, which is also called Joule's first law.
• A photoresistor (also known as a light-dependent resistor, LDR, or photo-conductive cell) is a passive component that decreases in resistance as a result of increasing luminosity (light) on its sensitive surface, in other words, it exhibits photoconductivity.
• The analog sampled filter will in its turn need yet another anti-aliasing filter, but this can often be implemented as a simple 1st order low-pass analog filter consisting of one series resistor and one capacitor to ground.
• Network wiring consists of a shielded twisted pair, with a characteristic impedance of , with a termination resistor at the end of the cable furthest from the controller to absorb signal reflections.
• A first order RC circuit is composed of one resistor and one capacitor and is the simplest type of RC circuit.
• To form a relationship between the voltage and current measured on the one hand, and the material's resistivity on the other, it is necessary to apply the distributed-element model by considering the material to be an array of infinitesimal resistor elements.
• Another benefit of the method is that it boosts the gain using a single resistor rather than a pair, thus avoiding a resistor-matching problem and very conveniently allowing the gain of the circuit to be changed by changing the value of a single resistor.
• Furthermore, the particular case of a capacitor or inductor changing through several parallel resistors makes an interesting example of multiple decay processes, with each resistor representing a separate process.
• For many systems, the terminator is a resistor, with a value chosen to match the characteristic impedance of the transmission line and chosen to have acceptably low parasitic inductance and capacitance at the frequencies relevant to the system.
• The tester consists of a large resistor that has a resistance similar to a car's starter motor and a meter to read the battery's output voltage both in the unloaded and loaded state.

Förberedelsen av sidan tog: 361,50 ms.